PRODUCTS AVAILABLE
Bonded Asbestos industrial brakes is a flexible, solid woven, asbestos based friction materials, made from yarn spun around brass-wire, which contributes considerably to its strength.
Asbestos industrial brake linings have a medium/high coefficient of friction combined with moderate temperature and wear resistance. It is available in roll form and segments, cones and special shapes can easily be cut from it. Being a flexible material it is possible to form it to radius when fitting it facilitate this operation, it may be heated uniformly to a moderate temperature to soften the impregnant. It is designed solely for use under dry conditions.
Length: in rolls of approximately 15 meters [ 50 ft. ]
Thickness: 4.8 mm [ 3/ 16"] to 19.1 mm [ 3 / 4"]
Width: 25.4 mm [ 1" ] to 463.6 mm [ 18¼" ]
| Recommended Operating Temperatures
|
Maximum Continuous Temperature - 125°C [ 257°F ]
| Recommended Mating Surface |
If steel, then forged or cold rolled with a Brinell of 200 or over, Cast steel is not recommended for use as mating surface.
Technical Data : Average
[ Data based on international standard test methods ]
|
Compressive Strength ( for 10% compression ): 633 kg / cm² [ 9,000 lbs/sq. In ]
Rivetholding Capacity: 900 kg / cm² [12,800 lbs/sq. In ]
Specific gravity: 1.75 gm/cc [ 0.06 lbs / cu.In ]
|
